3D Cultures 3D Bio-Printer Kullanıcı Kılavuzu - Sayfa 12

3D Yazıcılar 3D Cultures 3D Bio-Printer için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3D Cultures 3D Bio-Printer 16 sayfaları.

PRINTER & NOZZLE SETUP

Perform the following steps to prepare the printer for use.

1. Remove the printer from its packaging and place it on a flat, stable surface with plenty of ventilation

and a nearby AC power outlet.

2. Remove the any tape or cable ties holding the nozzle.

a. If the nozzle is not connected to the motion arm; There are a series on mounting holes for

the nozzle (figure below, left), line up to your desired placement and use the hex tool to

tighten both screws (figure below, right).

b. Future adjustments can be made by moving to different holes or moving the nozzle up and

down.

11 |

P a g e