3D Hobby Shop 70 AJ SLICK Montaj Kılavuzu - Sayfa 5

Oyuncak 3D Hobby Shop 70 AJ SLICK için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3D Hobby Shop 70 AJ SLICK 19 sayfaları.

Install tailwheel onto fuselage as shown, using QTY 2 4-40 screws and washers, with loctite.

Remove the covering over the pre-fabricated cooling holes in the bottom of the fuselage, as shown.

HINGING

The 70" slick comes with pre-hinged and pre-gap-sealed wings/ailerons to save time during your build.

You will need to hinge the tail. All tail hinges are the same type and work the same way. The below

instructions cover the use of polyurethane and epoxy glue. If you are using a type of specific RC-hinge

glue, follow the direction on the hinge glue bottle.