BLAM CR20 Manuel - Sayfa 6
Subwoofer BLAM CR20 için çevrimiçi göz atın veya pdf Manuel indirin. BLAM CR20 11 sayfaları.
Sayfayı Yazdır
Panel controls and features
A.POWER STATUS LED
The LED power glows green when the amplifier
is on and no problems are present.
The LED of protection lights if there is a
problem
B.PHASE SHIFT
Use this switch to help compensate for time
alignment problems in the system. Such
problems usually result from having the
subwoofer at a different distance from the
listener than the other speakers in the system.
C.HIGH LEVEL INPUTS
If your head unit does not have RCA
outputsyou can use the speaker outputs for
the audiosource for the subwoofer. Use the
supplied cable and wire harness and connect
the outputs properly as shown in the connec-
tiondiagram in this manual.
The AUTO POWER ON is for high
level (speaker-level) connections.
The subwoofer turns on automatically when
There is signal on the input and switches off
Automatically when it no longer detects
signal.
D.LOW PASS FILTER
His control permits you to define the frequency
range you want the subwoofer amplifier to
output. The subwoofer will reproduce all sound
BELOW the frequency you set.
E.BASS BOOST
He BASS BOOST feature will increase the
sound level in the bass frequencies.
J
I
G
D
E
B
F
H
F.INPUT GAIN CONTROL
After you have installed your system, turn this
control to minimum.
Turn the head unit on (and the subwoofer will
turn on via the remote connection). Turn the
head unit volume to about 2/3 full level.
Slowly turn up the subwoofer input gain control
until you hear a small amount of distortion. Then
reduce the level until the distortion is completely
gone. Level the control at this setting.
G.REMOTE LEVEL CONTROL PORTAL
Attach the included remote level control to
control the volume level of the subwooer
independently.
H.RCA INPUTS
Low level inputs are the recommended way
to introduce the audio signal to the subwoofer
if RCA outputs are present on your head unit
or other signal source (such as a sound
processor). Connect to remote turn-on terminal
on head unit.
I.FUSE
Do not use a fuse with a different value
and NEVER replace the fuse with a wire
or coin.
J.POWER INPUT TERMINAL
5
A
C