3D Hobby Shop YAK55 Montaj Kılavuzu - Sayfa 13

Oyuncak 3D Hobby Shop YAK55 için çevrimiçi göz atın veya pdf Montaj Kılavuzu indirin. 3D Hobby Shop YAK55 19 sayfaları.

-- Install the aileron servo into the wing as shown below. Inside the servo hole there is a piece of string added for

convenience to attach your servo wire with tape to help guide the servo wire to the wing root.

-- The pushrods for the Yak are assembled as shown below. At the control horn the ball link is screwed onto the

threaded end of the pushrod 5-6 turns. With the 2mm screw, washer and nut, the ball link is then bolted to the control

horn and tightened fully tight.

-- Use a drop of thick CA on the nut to lock it in place.

NOTE: the longest pushrod is for the elevator, and the two smaller equal length pushrods are for the ailerons.

-- The pushrod connectors for the servo arms are also shown in the photo above. The hole in the servo arm is enlarged

to accept the connector, and making sure there is a washer either side the nut is added although not tightened all the

way. The nut should only be made to be a snug fit so that the connector can still rotate. Add a drop of thick CA to the

bottom of the nut to secure it in place and allow to cure.

-- Use a 1.5mm hex tool to secure the set screw on top to hold the pushrod.

-- Repeat this process for the opposite wing.

-- Using a sharp knife, open the slot for the pull-pull rudder control horn as shown.