Cubic casja80l Kullanım Kılavuzu - Sayfa 5

Evcil Hayvan Bakım Ürünü Cubic casja80l için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cubic casja80l 15 sayfaları. Jellyfish aquarium

COMPONENT INSTALLATION

THE CUBIC JELLYFISH AQUARIUM HAS BEEN THROUGH

EXTENSIVE DEVELOPMENT AND TESTING TO ENSURE THAT IT

OFFERS THE BEST CONDITIONS AND CATERS FOR THE VERY

SPECIFIC NEEDS OF JELLYFISH. IMPORTANT: UNDER NO CIR-

CUMSTANCES SHOULD ANY FORM OF MEDIA, SUBSTRATE OR

DECORATION BE ADDED TO THE MAIN DISPLAY AREA.

IMPORTANT:

When filled with water, the aquarium will weigh approximately 120kg. The aquarium should therefore be placed

on a flat level surface capable of supporting a minimum recommended 150kg. Any support should also be of

sturdy construction to eliminate the chances of the aquarium toppling or falling should it be accidentally pushed

or knocked.

IMPORTANT:

The aquarium should be sited out of the reach of young children and away from direct sunlight where possible

as this may induce excessive algal growth and overheating of the water which can result in stress and damage

to any livestock present.

IMPORTANT:

Under no circumstances should power be supplied to the aquarium prior to it being filled and the circulation

pump submerged. Failure to do so may result in severe damage to the pump internals and loss of applicable

warranties.

IMPORTANT:

After siting the aquarium and ensuring that it is level, remove the rear top inspection panel to gain access to

the filtration chamber. Also remove the rear panel by sliding upwards on its guides to gain access to the

electrical control box mounting point. IMPORTANT: Under no circumstances should the electrical control box

be opened. Opening this box without authorization will result in loss of applicable warranties.

ELECTRICAL BOX

FIG. A

Secure the electrical box In place by

sliding it into the 4 securing points on

the rear inner panel. Then tighten the

2 securing screws

FIG. B

IMPORTANT:

The electrical control

box should always be located in such

a way that all incoming and outgoing

power cables do so from the

underside to prevent water entering

any seals.

page