3D innovations DeskCycle Kullanıcı Kılavuzu - Sayfa 5
Egzersiz Bisikleti 3D innovations DeskCycle için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3D innovations DeskCycle 16 sayfaları. Using the large display manual
Ayrıca 3D innovations DeskCycle için: Kullanıcı El Kitabı (12 sayfalar), Manuel (3 sayfalar)
Sayfayı Yazdır
Step 3: Level the Bike & Tighten Nuts
At this point the four nuts that attach the legs
to the Bike should be loose.
•
Place the Bike onto a smooth flat surface.
•
Tighten the four leg nuts using the supplied
Tool. Do not over-tighten the nuts!
Step 4: Install the Pedals
There is a Left Pedal and a Right Pedal. They are
marked with an L for Left or an R for Right on
the end of the pedal shaft.
•
Screw the Left Pedal into the Left Pedal Arm
COUNTER-CLOCKWISE.
•
Screw the Right Pedal into the Right Pedal Arm
CLOCKWISE.
MAKE THE PEDALS AS TIGHT AS POSSIBLE!!!
Using the bike with loose pedals will damage
the pedal arm threads!
Tips for Installing the Pedals:
1. Make sure the pedal is straight when
you screw it in.
2. Rotate the shaft with your fingers to get
the threads started.
3. If you can't get the threads started with
your fingers then it is cross threaded.
Unscrew the pedal, make sure the pedal
is straight, and then try again.
Step 5: Insert the Battery into the Display
•
There is a door on the back of the Display. It
snaps in and out. The latch is at the top. Pry the
top of the door out with your index finger.
•
Remove any plastic wrapping from the Battery.
•
Insert the Battery. Pay attention to the polarity.
•
Press the door back into the display. Insert the
bottom edge first.
Step 6: Install the LCD Display
•
Plug the Connector into the Display.
•
Carefully slide the Display onto the
Display Bracket as shown in the
picture.
Assembly (continued)
3