CubuSynth Exhaust V2 Kullanıcı Kılavuzu - Sayfa 3

Kontrol Ünitesi CubuSynth Exhaust V2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CubuSynth Exhaust V2 5 sayfaları. Expander module for the engine v2
Ayrıca CubuSynth Exhaust V2 için: Oluşturma Kılavuzu (5 sayfalar)

Sayfayı Yazdır

CubuSynth Exhaust V2 – User Manual

PCB V1.1 Jul 2023

1. Introduction

The Exhaust adds many features to your Engine VCO module like Sub-octaves, Mixing and a Gate

generated by the Chaos signal.

You can select one of the two VCO cores of the engine to Produce Square Waves one and two

octaves below the Oscillators frequency. You can blend between -1 and -2 octaves and Set the

volume they are Mixed into the Main "Mix" output.

The knobs "VCO1" "VCO2" and "AM" set the level of the selected waveform of each VCO and the

AM output from the Engine to the Main Mix. The "Ext In" Input is normalled from the RM output,

but you can plug in any other signal to go to the Main Mix.

The V Ref sets a Voltage between 0V and +10V which compares against the Chaos signal from the

engine (Chaos attenuator on the Engine doesn't matter). Whenever the Chaos signal is higher in

Voltage than the Knob setting, It will Give you a Gate or Trigger signal depending on the switch.

There is also a CV input, which offsets your V Ref and can create interesting Rhythms. This

function works best when the "Clock In" on the Engine is synced by your Main Clock.

Visual Demonstration of the Gate and Trigger Output:

Page 2