Dish Network DISH Player-DVR 522 Uzaktan Kumanda Kurulumu - Sayfa 13
DVR Dish Network DISH Player-DVR 522 için çevrimiçi göz atın veya pdf Uzaktan Kumanda Kurulumu indirin. Dish Network DISH Player-DVR 522 17 sayfaları. Dish network remote control setup guide
Ayrıca Dish Network DISH Player-DVR 522 için: Kullanıcı Kılavuzu (1 sayfalar), Başlarken (2 sayfalar)
Sayfayı Yazdır
222.book Page 69 Tuesday, July 25, 2006 1:30 PM
Programming the Recover Button for Remote Control 2
When your Remote Control 2 is shipped from the factory, RECOVER is set up to restore
satellite TV viewing by tuning your TV (or VCR) to channel 3, 4, and other inputs.
However, to use RECOVER with your remote TV (or VCR), you need to program
RECOVER with the specific channel (for example, channel 60) that you use to watch TV2
programming. The following instructions describe how to program RECOVER to tune your
remote TV (or VCR) back to a selected channel.
Using the Recover Button
The following setup is required to use RECOVER:
•
•
•
Note: Press any remote control button other than RECOVER to end this procedure.
Note: If RECOVER is not programmed to a specific channel, RECOVER will first try to
tune your TV to channel 3, then channel 4, and then other video inputs with each press of
RECOVER. You may need to press RECOVER up to 30 times to recover your satellite TV
video. If RECOVER is programmed to a specific channel (see page 69), RECOVER will
tune the TV to the specific channel (for example, channel 60).
The remote control must be set up to control the TV and, if installed, the VCR.
If a VCR is installed, make sure it is connected as shown on page 94.
On a remote TV, RECOVER must be programmed to tune your remote TV to the spe-
cific channel to receive TV2 programming (for example, channel 60), using the
instructions on page 69.
Remote Controls
The Recover Button
69