3D Robotics IRIS Manuel - Sayfa 3

Kamera Aksesuarları 3D Robotics IRIS için çevrimiçi göz atın veya pdf Manuel indirin. 3D Robotics IRIS 5 sayfaları. Tarot gimbal

Place the blue face plate over the camera, and secure

from the back with the two original screws.

Add face plate.

3 Connect

Follow these instructions to connect the gimbal to IRIS. This will allow you to control the tilt

of the camera in flight using your RC transmitter. To enable automatic camera stabilization

without RC control, skip to the step 3: power.

Locate the orange, red, and brown three-wire cable protruding

from the bottom of IRIS.

Thread the cables through the interface plate. Locate the pins on the Tarot

board. Connect the brown wire to a - (ground) pin and the orange wire to the T

(tilt) pin. Do not connect the red wire.

Thread cables here

tighten

attach orange wire to tilt (T)

attach brown wire to ground (-)