Aerial AD 110 Kullanım Kılavuzu - Sayfa 7
Nem Alıcı Aerial AD 110 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Aerial AD 110 13 sayfaları. Aerial ad 110 dehumidifier instruction manual
Sayfayı Yazdır
5.3 Operation panel AD 110
Hygrostat
5.4 hygrostat control
The air dryers of the AD-series dispose of a hygrostat for setting the required
humidity value. This hygrostat is located in the front of the unit. It makes that the air
dryer cuts in as soon as the ambient humidity exceeds the preset value. If the
humidity value falls below the set value, the hygrostat will switch off the appliance.
The following operating modes can be set by means of the hygrostat
Pos. 0 = Unit is switched off
Pos. 1 = Continues operation
80%
= The dehumidifier switches off when
a humidity of approx. 80% r.h. has
achieved. And switches on again
when humidity is higher than 80%.
60%
= The dehumidifier switches off when
a humidity of approx. 60% r.h. has
achieved. And switches on again
when humidity is higher than 60%.
40%
= The dehumidifier switches off when a humidity of approx. 40% r.h. has
achieved. And switches on again when humidity is higher than 40%.
20%
= The dehumidifier switches off when a humidity of approx. 20% r.h. has
achieved. And switches on again when humidity is higher than 20%.
The marks at the rebound curve and the humidity values mentioned above are to be
seen as reference values only. The hygrostat of the air dryer and a hygrometer
located inside the room to be dried most probably will not indicate the same values.
It is recommended to change the setting at the air dryer until the desired room
humidity has been reached.
neon „Operating"
Operation time counter
page 7 of 13