Abbott FreeStyle Libre 2 Başlayın - Sayfa 4
Ölçüm Cihazları Abbott FreeStyle Libre 2 için çevrimiçi göz atın veya pdf Başlayın indirin. Abbott FreeStyle Libre 2 15 sayfaları. Flash glucose monitoring system 4.5”
Ayrıca Abbott FreeStyle Libre 2 için: Başlayın (9 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Başlayın (15 sayfalar), Manuel (12 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar)
Sayfayı Yazdır
4 Steps to Apply Sensor
Sensors stick better when you wash, clean, and dry your
arm before application.
01
Selecting a Sensor Site
Select an area on the
back of your upper arm
stays fl at (no bending or folding). Choose a site that is at least
away from an insulin injection
1 inch (2.5 cm)
discomfort or skin irritation by
one most recently
used. Make sure the site is
avoid interference with the sensor.
02
Preparing the Skin's Surface
non-moisturizing, fragrance-free
Only use
where you'll apply the sensor. Use the alcohol wipe provided in
the sensor kit to
remove any oily
fully dry
before applying the sensor. This is especially important
if you plan to apply the sensor after you shower or swim.
Pg 6 of 28
that generally
site. Prevent
selecting a site other than the
clean-shaven
soap to wash the area
residue.
Allow your skin to
03
Preparing the Sensor
Peel lid
applicator.
Press down fi rmly on the sensor applicator until it comes to
a stop.
Lift the sensor applicator
sensor applicator is now ready to apply the sensor.
to
04
Applying the Sensor
Place the sensor applicator over the application site,
and hold for a few seconds.
from your body.
sensor down and running your fi nger along the sensor adhesive.
unscrew cap
from the sensor pack and
Line up marks
on the sensor applicator and pack.
out of the sensor pack. The
Gently pull
Make sure the sensor is secure
Quick Tip
Make sure to rotate the site to allow skin to fully heal.
Switching arms each time can help.
Get support and information at FreeStyleLibre.us
from the sensor
CAUTION:
Sensor applicator
will now contain a needle.
Do not touch inside sensor
applicator or place back
inside sensor pack.
NOTE:
Sensor pack and
sensor applicator codes
must match or glucose
readings may be inaccurate.
press fi
rmly,
the sensor applicator away
by pressing the
Pg 7 of 28