ABBOTT & ASHBY ATBM280/6 Kullanım Kılavuzu - Sayfa 7
Öğütücü ABBOTT & ASHBY ATBM280/6 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ABBOTT & ASHBY ATBM280/6 8 sayfaları. 6” industrial buffing machine
Sayfayı YazdırATBM280/6 Operating Manual
WARNING!
Do not use bench grinders in areas where there is a risk of explosion or fire from
combustible materials, flammable liquids, paint, varnish, petrol etc. flammable gases and
dust of an explosive nature. As a precaution it is recommended that you consult an expert
on a suitable fire extinguisher and its use.The metal particles (sparks) which are produced
during grinding are hot and could ignite any combustible material in the vicinity of the
operation.
GETTING STARTED
ACCESSORIES
The bench grinder is supplied with the following accessories:
2 eye shields with mounting brackets and 2 tool rests
CAUTION. Always ensure that the bench grinder is switched off and plug is removed from
the power point before making any adjustments.
To fit the eye shields locate the nut, screw and washers provided through the slot in the eye
shield and hole on the grinding wheel guard and finger tighten. Position the eye shield so it
does not come in to contact with the grinding wheel. Tighten the nut and screw to secure the
eye shield in place.
Attach the tool rests using the bolts and securing knobs provided and adjust to the correct
position. The gap between the tool rest and grinding wheel should be set to 2mm.
BENCH MOUNTING
The Grinder can be secured with screws or nuts and bolts. Locate the mounting holes. The
length of the bolts or screws will depend on the thickness of the bench. Where a steel
bench is used it is best to mount the grinder on to a board, then attach the board to the
bench, this will also minimise vibration.
SWITCHING ON AND OFF
Before connecting to the power supply rotate the wheel by hand to ensure that it is running
free from obstruction. Connect to the mains supply and press the rocker switch to the ON
position (l). To stop the machine simply press the rocker switch to the OFF position (o).
GENERAL INSPECTION
Regularly check that all the fixing screws are tight. They may vibrate loose over time.