Distech Controls Allure EC-Smart-Air-C Kurulum Kılavuzu - Sayfa 9
Aksesuarlar Distech Controls Allure EC-Smart-Air-C için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Distech Controls Allure EC-Smart-Air-C 10 sayfaları.
Sayfayı Yazdır
ECx-4xx Series devices and room devices are factory-set with the EOL set to OFF by default.
Setting the Allure EC-Smart-Air Sensor Subnet ID
Each Allure EC-Smart-Air communicating sensor connected to a controller's Subnet Port must be set to a unique subnet ID address. The address is set
through the DIP switch located next to the Subnet Port connectors. Please refer to section
Switch Position
1
OFF
ON
OFF
ON
OFF
ON
OFF
The Allure EC-Smart-Comfort sensors and Allure EC-Smart-Air sensors share the same addressing range.
Maintenance and Cleaning
Gently clean the device with a soft, lint-free cloth slightly moistened with a solution of mild liquid dish soap and warm water or disinfect the device with a
soft cloth slightly moistened with a 70% isopropyl alcohol.
Do not directly spray any liquid or disinfecting solution on the device. Do not clean with any other chemicals products.
2
OFF
OFF
ON
ON
OFF
OFF
ON
Connectors and DIP Switch Location
3
OFF
OFF
OFF
OFF
ON
ON
ON
4 (EOL)
ON or OFF
See Subnetwork
Bus
Topology
and
EOL
Terminations
[pg. 3].
Allure EC-Smart-Air Subnet
ID Address
1
1
2
3
4
5
6
9 / 10