Distech Controls Allure ECL-300 Kurulum Kılavuzu - Sayfa 14
Aksesuarlar Distech Controls Allure ECL-300 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Distech Controls Allure ECL-300 16 sayfaları.
Sayfayı Yazdır
Bus Network Topology: 22AWG (0.65mm) Unshielded Twisted Pair Network Cable
Controller
Communicating Sensor
Figure 16:
L
W
Network: Bus Topology
ON
ORKS
To temporarily access the L
ON
port located on the lower edge of the Allure EC-Smart-Vue sensor. Wire a standard ⅛" (3.5 mm) three-conductor (stereo jack) or two-conductor (mono
jack) as shown below.
LON1
LON2
Mono Jack
Figure 17:
⅛" (3.5 mm) Stereo or Mono Jack Connection for a L
14 / 16
Cat 5e Cable Subnetwork Bus Provides:
· Room Device Data communication
· L
ON
Port Settings jumpers are Enabled
W
LAN for commissioning and maintenance purposes, connect a L
ORKS
LAN Access
LAN Access
Connector
Connector
OR
To LON USB
Network Interface
Standard Net to
Subnet Port
Settings:
DISABLED - this
is the factory
default setting
W
Network when Net to Subnet
ORKS
LON1
LON2
Stereo Jack
LON USB Network
Interface
W
Network Interface
ON
ORKS
For a Few
Controllers ONLY:
Net to Subnet Port Settings
Optionally Enabled
W
USB network interface to the audio plug
ON
ORKS
- Temporary
Commissioning and
Maintenance
Connection