Distech Controls MS2 Series Donanım Kurulum Kılavuzu - Sayfa 2
Güvenlik Sensörleri Distech Controls MS2 Series için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Distech Controls MS2 Series 5 sayfaları. Mini infrared multi-sensor
Sayfayı YazdırRJ9
connector
Multi-sensor back view
Note: The spring screwing depends on the suspended ceiling thickness. It is not necessary to screw it completely to fix it.
Mini Multi-Sensor Range
Infrared technology
MS2-I-P
MS2-I-PL
MS2-I-PLT
Multi-Sensor Configuration
This document provides operation information to help you configure your multi-sensor.
Infrared multi-sensor pairing
This section indicates how to initiate the communication between the infrared remote control and its receiver through the attribution
of a zone address. This zone address must be set between 0 and 30 and must also be configured in the controller (please refer to
the controller's documentation for more information).
It is recommended to assign an address zone different from 0 to avoid disturbances from light interference with lighting,
especially neons, on infrared frames.
The remote control is set for zone 0 by default (universal address): it can communicate with all receivers with no relation to the zone
set in the controller.
Associating an EC-Remote to a particular controller allows managing working areas in differentiated ways, in case of open plan offices
for example.
A common zone address must be set in order to associate an infrared receiver to a remote control:
Rear
spring
Infrared mini multi-sensor: presence detection
Infrared mini multi-sensor: presence detection and Lux level measure
Infrared mini multi-sensor: presence detection, Lux level and temperature measures
MS2 Series
2/5