CAMDEN Lazerpoint RF RX-92 Kurulum Talimatları Kılavuzu
Alıcı CAMDEN Lazerpoint RF RX-92 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. CAMDEN Lazerpoint RF RX-92 14 sayfaları. Full-function receiver
Sayfayı Yazdır
Section 1
General Description
Camden Lazerpoint™ Radio Controls comprise the following
models:
CM-TX-9 Wall switch ready transmitter
CM-RX-91 Basic Receiver
CM-RX-92 Full function (dual relay) Receiver.
This instruction manual covers the TX-9 and RX-92 models
as well as the plug-in daughterboard's, and related
Camden Lazerpoint™ RF is the first system designed to
address the specific needs of the Automatic Door industry.
Unlike typical "garage door" RF, Camden's Lazerpoint™
operates at 915 MHz frequency to "cut through" the noise
and clutter, and penetrate typical building materials to
ensure a reliable installation every time.
TX-9 transmitters utilize readily available AAA batteries,
and special circuitry assures long life. A proprietary piezo
sounder is used to annunciate low battery, battery level,
and "stuck switch" conditions.
Two receiver models are offered – the basic single relay
RX-91, and the full function RX-92. The RX-92 offers 6
operating modes including dual independent channels,
latching, and bi-directional sequencing.
Both receivers can be fitted with plug-in daughterboard's
ensuring compatibility with older RF technologies. Up to two
such boards may be installed at one time, simultaneously
allowing the receiver to work with three different frequencies
– another Camden exclusive.
Both receiver models feature convenient terminal strip
Connections, visual signal strength indicators, and 40 code
memory with push-and-learn technology.
Lazerpoint™ RF RX-92
Full-Function Receiver
Installation Instructions
Section 2
Installation
Mounting
The TX-9 is designed to mount behind a switch in a wall-
box, post, or other suitable enclosure. Double sided tape is
used to attach the circuit board and battery holder securely
to the enclosure. Even though the circuit board is conformal
coated, care should be taken to ensure the transmitter does
not get wet.
The RX-92 receiver is designed to mount inside the automatic
door header. Screw holes are located at each end of the
receiver case, or the included velcro may also be used to
hold it securely.
For Dimensional information refer to RX-92 Electrical and
Mechanical Drawing on Page 5.
Wiring
Wiring of this unit is dependant on the application and mode.
Determine the appropriate mode, and then proceed to the
section and drawing indicated.
Note: Do not use the Lazerpoint RF system as a Safety
device!!. If safety devices are used, always wire them directly
to the operator control box.
Section 3
Set-up Instructions
The RX-92 has two relays, and three potentiometers with two
1 – 30 second adjustable Hold time (or delay-on-release)
and a 1 – 15 second delay-on-activate for the second relay.
The 4-position dip switch selects from one of 6 different
operating modes.
Dip switch #4 controls the display of LED 1 & LED 2. When
set to OFF, it will display the operation of the associated
relay(s). When set to ON, it will blink a count to indicate the
received signal strength. To facilitate set-up, set to OFF.
Page 1 of 13