3D Upfitters Carbon Air Filter Kurulum Kılavuzu - Sayfa 5

3D Yazıcılar 3D Upfitters Carbon Air Filter için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3D Upfitters Carbon Air Filter 12 sayfaları. Air filter & vents

Sayfayı Yazdır
This view is from inside the enclosure looking at the filter attached to the outside. Insert
the long 40mm M4 cap head screws from inside the enclosure into the holes in the
filter on the outside of the enclosure. Insert the screws only part way into the filter to
make sure the screw ends have caught into the nuts before starting to tighten.
Smaller enclosures such as the Prusa have 60mm holes, and thus need an adapter. To
prepare the 80mm to 60mm adapter insert an M4 square nut in each corner as shown
below:
Copyright 2022 3D Upfitters LLC
5