3D Upfitters AnkerMake M5 Kurulum Kılavuzu - Sayfa 9

Muhafaza 3D Upfitters AnkerMake M5 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3D Upfitters AnkerMake M5 18 sayfaları.

As with the front door, adjust how the door hangs by loosening the hinge screws, using

the strike plates to hold the door to the latches, and then tightening the hinge screws.

Note that the left side will also be the location of the fresh air intake vent, but that will

be installed after the enclosure is placed over the printer.

3. Back Panel

The back of the enclosure is shown below. The four corner connectors are mirror

images of the front. The large hole is either for an air ﬁlter (purchased separately) or

can be covered by the included plastic disc using M4 12mm screws. On the top and

each side are "mid panel corner connectors," which are simple L-shapes.