3DGence DOUBLE P255 Bakım Kılavuzu - Sayfa 3

3D Yazıcılar 3DGence DOUBLE P255 için çevrimiçi göz atın veya pdf Bakım Kılavuzu indirin. 3DGence DOUBLE P255 19 sayfaları.

1. HOTENDS CLEANING

Recommended frequency:

Each time after completed printing, clean the hotends by removing the remaining molten/burnt material that may

be on the outside of the nozzle

For this purpose:

Procedure for hotend cleaning.

1. Wear protective gloves.

2. In the TUNE menu, set the heating temperature for the given hotend using +/- keys. Choose Tool 0 temp.

option for T0 hotend and Tool 1 temp. option for T1 hotend.

3. Ensure good access to the hotend using the RISE HEATBED or LOWER HEATBED option in the MENU. Press

and hold the keys to move the heatbed smoothly up or down. Press the key once to move the heatbed at a

short distance.

4. Using a non-flammable material or tweezers, gently remove the remaining molten/burnt material.

5. After cleaning the hotend, switch the heating off (TUNE → Tool 0 temp. / Tool 1 temp. → RESET).

3DGence DOUBLE P255 printer can also clean the hotends automatically by extruding a section of material. This

function is particularly useful when the user has to change the material or remove the remains of old filament or if

the hotend has not been used for a long time and is slightly clogged. The automatic hotend cleaning assistant is

available during printing and in the idle mode.

Hotend cleaning assistant:

1. Choose MATERIALS and then CLEAN NOZZLES in the main menu.

2. Specify the hotend to be cleaned – MODEL MATERIAL for T0, SUPPORT MATERIAL for T1 or BOTH TOOLS for

both hotends. Confirm the choice with CONTINUE key.

3. The process will start automatically.

4. After completed process, remove the rest of the filament extruded from the hotend.

3DGence DOUBLE P255 - maintenance activities | version 07.2021

each time printing is finished.