CAME FAST Series Kurulum Kılavuzu - Sayfa 13

Garaj Kapısı Açıcı CAME FAST Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. CAME FAST Series 17 sayfaları. Straight transmission arm
Ayrıca CAME FAST Series için: Montaj Prosedürü (2 sayfalar)

Sayfayı Yazdır

7 Maintenance

7.1 Periodic maintenance

Periodic maintenance to be carried out by the end-user is as follows: wipe clean the glass surface of the photocells;

check that the safety devices work properly; remove any obstructions.

We suggest checking the state of lubrication and tightness of the anchoring screws on the operator.

To check the efficiency of the safety devices, move an object in front of the photocells when gate is closing. If the operator inverts

the motion or stops, the photocells are working properly.

This is the only maintenance procedure to be carried out with the power source connected.

Before performing any maintenance procedures, cut off the main power, to prevent possible accidents due to gate movement.

To clean the photocells use a water dampened cloth. Do not use solvents or other chemical products which may ruin the

devices.

In the event of any strange vibrations or squeaking, lubricate the joints with grease, as shown in the diagram.

Make sure there are no plants within the photocell's beam, and that the gate motion is free of any obstacles.

7.2 Trouble shooting

MALFUNCTIONS

THE FLASHER DOES NOT WORK

Check and remedies • There is no power

• The gearmotor is released

• The transmitter's batteries are run down

• The transmitter is broken

• The stop button is either stuck or broken

• The opening/closing button or the key selector are stuck

The gate will not

• The photocells are engaged

open nor close

The gate opens but

• The bulb is burnt

will not close

POSSIBLE CAUSES

• Check that the power is up

• Call assistance

• Replace batteries

• Call assistance

• Check that photocells are clean

and in good working order

• Call assistance