CAME v6000 Kurulum Kılavuzu - Sayfa 8

Garaj Kapısı Açıcı CAME v6000 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. CAME v6000 17 sayfaları. For garage doors

Sayfayı Yazdır

1. Adjusting Sensitivity

Remove the cover of the operator and the cable clamp. Slide out the electrical cable and route into the through-hole.

Reﬁ t the cable clamp so that the hole is blocked.

Use the screwdriver to pierce the preformed hole to pass the microswitch electrical cables through and ﬁ t the cables into the micro. Secure the micro to the operator.

Connect the connectors in the respective positions on the microswitch.

Reconnect the cables as in their original conﬁ guration (N.O). - C).

Secure the cover to the operator.

Operator latch

Latch

To release the operator, pull the cord ⓒ downwards.

Locking

To lock the operator back into place, use the transmitter or a command button.

ELECTRICAL CONNECTIONS

Before intervening on the device, disconnect the line voltage.

Power supply (V - 50/60 Hz) 230 AC

Control board features:

• Motion control and obstacle detection

• Reopening during closing

• Adjustable automatic closing time

• Open-stop-close-stop from transmitter and/or button

• Courtesy light (stays on for a set time of 3 minutes and 30 seconds after an opening command.

ⓒ

FUSE TABLE

Line fuses (A)

Courtesy Lights (W)

LED

≤ 1