3DLabPrint Focke-Wulf Ta 152 C Kullanıcı Kılavuzu - Sayfa 7
Oyuncak 3DLabPrint Focke-Wulf Ta 152 C için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 3DLabPrint Focke-Wulf Ta 152 C 9 sayfaları. Fully 3d printable upgrade to short wing
Sayfayı Yazdır5.2.1 Fuselage Ta 152 C update for rubber band
Parts F4 and F2 can be printed in improved ACES version for fixing the wing assembly with
rubber bands. Use 3mm carbon rod for improved rubber wing fixing. Don't glue carbon rod
in part F4 for easy rubber change.
You will need:
2 pieces of 3mm carbon rod with 125mm lenght.
F4
39g/1.37oz
6. Servo installation
Extend the servo leads, remove servo brackets and install the prepared servos to the wing
servo bays. Use a 1mm steel wire with Z bends as a linkage between the servos and aileron
control horns. Elevator servo will be fixed by servo holder or glue in the fuselage.
See example in video guide #6 for Ta 152 H version
you will need:
3x HXT900, or opt1, opt2,
or any similar sized servos
23x12x26 mm / 0.74x0.42x0.78 inches
2x 300mm servo extension
Snap knife, Z pliers
... print your plane | www.3DLabPrint.com
F2
50g/1.74oz
opt3
page
F2 & F4 for rubber
banded wings
7