Altman WL-130 Kurulum Kılavuzu - Sayfa 3

Çalışma Işığı Altman WL-130 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Altman WL-130 4 sayfaları. Led work light

Sayfayı Yazdır
LED Work Light
INSTALLATION AND SET UP
Power Requirements
WARNING! The LED Work Light should be connected to a constant circuit or a relay device. It should never be connected to a
dimmer or circuit controlled by a dimmer. Read this section carefully on how to properly connect your fixture.
WARNING! All LED Work Light are shipped prewired from the factory. The wiring information in Table 1 is shown for field wiring
information and must be performed by a qualified and licensed electrician. Before performing any field wiring, refer to and read the
warnings contained in
The LED Work Light operates on 100 to 277VAC, single phase only and draws a maximum of 130 Watts. This luminaire only offers
ON or OFF operation and should never be connected to a dimmer or a dimmer-controlled circuit (even if the dimmer is set to NON
DIM mode).

Connecting Power

The LED Work Light is supplied with a five-foot, three conductor jacketed AC input tail. This tail can be connected to any single-phase
100 to 277 VAC power source either via direct connection in a junction box or a user-supplied and properly rated AC input connector
(by others).
IMPORTANT! The LED Work Light must be connected to and properly grounded to an viable earth ground.
Mounting
The LED Work Light is simple to install and position where work lighting is needed. The unit is supplied with a C-Clamp, Diffuser
Frame, and Safety Cable. When mounting the LED Work Light, you must follow all national and local codes for safe installation and
use. Unit weight, without accessories is 12.0 pounds / 5.5 kilograms.
Luminaire Yoke Assembly
Mounting Hole (1/2-inch / 12.7 mm,
C-Clamp supplied with unit)
Hinged Accessory Door
(Diffuser Frame
supplied with unit)
NOTE: A safety cable (supplied with unit)
should be used and may be required by
codes when hanging this luminaire.
"Important Information" on page
Table 1: AC Input Wiring
Wire Color (100 - 277VAC)
Brown
Blue
Green/Yellow
12.0 in / 304.8 mm
Figure 1: LED Work Light Features
1.
Purpose
Main / (L)ine
(N)eutral
Ground / Earth
(add 2 in / 50.8 mm for handles)
I
G
NSTALLATION
12.6 in / 320.0 mm
8.05 in /
204.5 mm
6.0 in /
152.4 mm
Tilt Lock Off
Handle (x2)
6.0 in /
152.4 mm
Power Requirements
UIDE
3