Acoustic Research AWD209 Kullanıcı El Kitabı - Sayfa 11

Kulaklık Acoustic Research AWD209 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Acoustic Research AWD209 13 sayfaları. 2.4ghz digital wireless stereo headphones

Sayfayı Yazdır

1. Product Information

•

Confirm that the headphones are turned on (the LED is blue) and tuned to the

transmitter. If the LED on the right headphone is flashing blue, the headphones

are not tuned to the transmitter. Press the link key on the headphones and on the

transmitter's back panel to tune the headphones.

•

Check that the headphone volume is turned up.

•

If you're using a variable output audio source (like a headphone jack or variable

output on a TV set), make sure the source component's volume is set high enough

for the transmitter to detect.

•

If you are using a Tape 2 Monitor output from your receiver/amp as the audio output,

check that you have pressed the Tape Monitor/Tape 2 button on the front of the

receiver. This will turn on the Tape 2 outputs, which may not have been active.

Interrupted sound

•

Move closer to the transmitter with the headphones on. Sending the signal

through certain materials, such as glass, tile, and metal, can decrease the effective

transmitting distance of the system.

LEDs fail to light up

•

Make sure the headphones are charged and that the transmitter is properly

connected to the audio source. Then, move the headphones close to the transmitter

and press the headphone power button again.

Headphones shut off automatically

•

Check the LED on the right headphone. If it's blinking, you've lost the transmitter's

signal. Move closer to the transmitter. If you don't see the LED, the headphones'

rechargeable battery needs to be recharged. Use the AC adapter to recharge the

headphones.

rouBleSHootInG