diversey CO350.5X Manuel - Sayfa 5

Temizlik Ekipmanları diversey CO350.5X için çevrimiçi göz atın veya pdf Manuel indirin. diversey CO350.5X 11 sayfaları.

Sayfayı Yazdır

Preparation for operation

Batteries

Caution:

Only maintenence-free gel traction block batteries may be used!

Please follow the instructions of use for your battery charger!

Safety measures when working with batteries:

• Protective goggles must be worn when working on the

batteries.

• Do not subject batteries to an open flame or heat as there is a

danger of explosion from the electolytic gas present in the

cells!

• No smoking!

• Danger of chemical burns!

Caution:

The battery must always be clean and dry. Do not place any

metallic objects on the battery.

The integrated charging unit is only suitable for maintenance-free

gel traction block batteries.

Battery connection diagram

Caution:

Batteries may only be installed or dismounted by customer

service personnel or specialists approved by Diversey who are

aware of all the safety regulations that apply here!

50A

Charger

BMS

Dashboard

Control

Charging procedure (traction block batteries with integrated charging

unit)

• Stand the machine on the parking support

before starting the charging procedure.

• Disconnect the battery from the machine using the battery disconnection

socket.

• Plug the power supply cord into the mains socket.

• The yellow indicator lights up permanently until

approx. 90% of the battery capacity has been

reached. After that, the indicator blinks until the

battery is fully charged.

• When the charging process is complete, the

green indicator lights up.

In order to protect the battery, the charging sequence is not

started after a short period of use of less than approx.15 minutes,

and the green lamp lights up immediately.

In this case, the battery is charged to more than 75%.

• Leave the power supply cord connected to the mains until you use the

machine again. The on-board charger unit automatically monitors and

charges the batteries. The energy consumption in the mode is limited to a

few milliwatts.

• If a fault occurs during the charging process as the result of a defect in the

charging unit, an interruption of a cable or a defective battery cell, the red

indicator will light up.

After completing the charging and with immediate use:

• Unplug the connection to the mains socket.

• Connect the battery to the machine with the battery disconnection socket.

Charging procedure (traction block batteries with external charging unit)

• Check that the machine is switched off.

• Disconnect the battery from the machine using the battery disconnection

socket.

• Connect the battery disconnection socket to the external battery charging

unit (pay attention to the voltage from the mains supply socket).

Caution:

Follow the instructions of use for your battery charger!

Attaching tools

• Switch the machine off.

Check:

• that the brushes are not below the red marking and that the bristle length is

no less than 1 cm.

Working with worn out, damaged and or wrong tools, could result

in possible damage to floors or their protective layers.

• Place the machine on the parking support.

• Remove the brush holder (2) by screwing off the

triangular handle (1).

• Insert the brush into the brush housing.

• You can push the brush upwards with your right

hand so that it will be taken up by the centring

hexagon in the brush housing.