Alto X4 Kullanıcı Kılavuzu - Sayfa 6

Çapraz Geçiş Alto X4 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Alto X4 13 sayfaları. 3-way stereo/4-way mono active crossover

Sayfayı Yazdır
14
15
Ch2 LOW-MID Crossover Frequency
16
17
18
Ch2 MID-HIGH Crossover Frequency
19
20
21
Power switch:
Turn the power on or off.
Clip LED:
It means that some band has resulted in clipping distortion when the LED is glittering. It is regarded as normal
if it is glittering only one or two times. But if it lasts for a long time, you should reduce the input signal to avoid
audio distortion.
Mute switch:
These buttons are used to mute each kind of frequencies outputs.

3.2 The Rear Panel

22
AC INPUT
110-120V
95-120V /210-240V 60-50Hz
Rated Power Consumption 10W
220-240V
FUSE:
210-240V: T100mAL 250VAC
95-120V: 200mA 250VAC
REPLACE FUSE WITH CORRECT
TYPE ONLY
Apparaten skall anslutas till
jordat uttag nar den ansluts
A101
till ett natverk
3WAY- STEREO
/
(4 WAY- MONO)
23
22
23
24
25
Ch1 Constant Directivity Boost
26
27
28
29
Ch1 HIGH Phase Inversion
30
31
32
33
Ch2 Constant Directivity Boost
34
35
36
37
Ch2 HIGH Phase Inversion
38
Ch2 LOW Gain
Ch2 LOW Mute
Ch2 MID Gain
Ch2 MID Mute
Ch2 HIGH Gain
Ch2 HIGH Mute
HIGH
MID
PHASE
PHASE
HIGH OUT 2 / (MID OUT)
MID OUT 2 / (LOW OUT)
36
38
37
35
X34 3-way stereo / 4-way mono active crossover
3-WAY STEREO MODE
Ch1 Line Input
Ch1 LOW Output
Ch1 MID Phase Inversion
Ch1 MID Output
Ch1 HIGH Output
Ch2 Line Input
Ch2 LOW Output
Ch2 MID Phase Inversion
Ch2 MID Output
Ch2 HIGH Output
PUSH
STEREO
MONO
NEW
TIDE
CD
3
2
1
BOOST
MODE
LOW OUT 2 / (SUB OUT)
INPUT 2 / (NOT USED)
CHANNEL 2
34
33 32
31
Fuse Holder
AC Inlet
Stereo / Mono Mode
5
SUB Gain
SUB Mute
SUB-LOW Crossover Frequency
LOW Gain
LOW Mute
LOW-MID Crossover Frequency
MID Gain
MID Mute
HIGH
MID
PHASE
PHASE
HIGH OUT 1 / (HIGH OUT)
MID OUT 1 (NOT USED)
LOW OUT 1 / (NOT USED)
CHANNEL 1
27
30
29
28
26
4-WAY MONO MODE
Line Input
Constant Directivity Boost
(not used)
(not used)
(not used)
High Phase Inversion
HIGH Output
(not used)
(not used)
SUB Output
LOW Phase Inversion
LOW Output
MID Phase Inversion
MID Output
PUSH
NEW
TIDE
CD
3
2
1
BOOST
INPUT 1 / (INPUT)
25
24