ClearChoice Premium Series Kullanım Kılavuzu ve Kurulum Kılavuzu - Sayfa 3

Su Sebili ClearChoice Premium Series için çevrimiçi göz atın veya pdf Kullanım Kılavuzu ve Kurulum Kılavuzu indirin. ClearChoice Premium Series 7 sayfaları. Under sink drinking water system

Sayfayı Yazdır

Step 3. – Install Stage 2 Carbon Filter

Follow the instructions in Step 2. to install the stage 2 carbon filter in the sump on the right hand

side of the unit. The Stage 2 carbon filter is gray in color with black end caps.

Step 4. – Select an Installation Site

Your water filter system was designed to be compact enough to fit under most kitchen sinks.

However, the system may be installed in a basement, closet, crawl, space, or wherever it is most

convenient. If you select an alternative installation area other than under your kitchen sink, you

may need to purchase some additional water tubing which is generally available at any hardware

store. When determining the installation site, access to a cold water line is important. To

accommodate filter changes, we recommend that you leave at least 4 inches of clearance beneath

the filter housing sumps.

Step 5. – Mount the Filtration Unit Assembly

The mounting bracket has pre-drilled keyhole slots for easy mounting to the wall of your kitchen

cabinet, wall, or other suitable sturdy base. Using the bracket itself as a template, mark the location

for the mounting screws. Then, drill 1/8" pilot holes (this will make it easier to set the screws).

Install 2 suitable screws and tighten them until the heads are about 1/8" from the wall. Hang the

filtration unit assembly on the mounting screws and then hand tighten the screws.

Step 6. – Drill Hole for the Faucet

The faucet should be installed in a manner that all overflow will run into your kitchen sink. This

will require you to drill a hole in either your countertop immediately adjacent to the sink, or in the

sink itself (usually the sink itself), unless you have an unused or capped hole already present.

Locate a desirable location for your faucet. Most homeowners prefer to mount the faucet in the rear

left corner of the sink or on the back edge to the left of the main faucet. Make sure that you will be

able to access the threaded portion of the faucet on the under sink of the sink/countertop following

installation – you will need access to this to attach the water line connections.

For Stainless Steel Sinks:

• make a small indent with a center punch as a starting point for drilling

• drill a pilot hole with a 1/8" or similar sized bit

• drill hole for the faucet with 1/2" bit

For Porcelain Enamel Sink:

• place a piece of tape over the area to be drilled to help prevent chipping of the porcelain

• drill a pilot hole with a carbide-tip pilot drill bit (1/8") - when drilling, drill slowly and

carefully.

• drill out hole for the faucet with a 1/2" porcelain cutter kit

• remove tape and clean away any small chips

For Formica Countertop:

• counter must be at least 5/8" thick