3DUpFitters Artillery Sidewinder X1 Enclosure Kit Kurulum Kılavuzu - Sayfa 8

3D Yazıcılar 3DUpFitters Artillery Sidewinder X1 Enclosure Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 sayfaları.

Sayfayı Yazdır

Now that the latches are mounted it is time to connect the

strike plates. Each plate comes with a squishy adhesive

covering the same size of the plate. Carefully attach the

adhesive side to the acrylic at the location of each latch.

Then, adjust the width of the metal strike plate so that it is

held on by the pressure of the two sides of the plate. The

adhesive covering will keep the metal strike plate from

scratching the acrylic.

2. Left Side Panel

Attach the left side to the front forming an L-shape

that will stand up on its own, then attach one L and

one R connector at the back. Then attach the two

mid-panel connectors on the top and back as

shown.

The vent is inserted from the outside and attaches

with the standard M4 10mm screws.

3. Back Panel

The back of the enclosure is shown to the right. The

four corner connectors are mirror images of the front.

The large hole is either for the fan, the optional an air

ﬁlter (purchased separately) or completely covered up

by printing a cover on Thingiverse. On each side and

top are "mid panel corner connectors".

Make sure that the fan is oriented to blow air out

of the enclosure.