3DUpFitters Ender 3 S1 Enclosure Kit Kurulum Kılavuzu - Sayfa 12

3D Yazıcılar 3DUpFitters Ender 3 S1 Enclosure Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters Ender 3 S1 Enclosure Kit 17 sayfaları.

Sayfayı Yazdır

Use access through the doors to attach

the top of the enclosure using M4 12mm

screws. You'll attach the top on the four

corners, and to each of the mid-panel

connectors as well. The slit is towards

the front, and the small access hole for

the ﬁlament runout sensor cable should

be on the right. The view shown at the

right is from above facing the front of the

printer.

Attach the ﬁlament sensor to the L-

bracket as shown using the silver screw

that was supplied with the printer to

attach the sensor to the Creality spool

holder.

Instead, you can use any spool holder

on top of the enclosure and run the

ﬁlament through the ﬁlament sensor and

directly to the extruder. Note: 3D

UPﬁtters spool holder not included.