3DUpFitters Ender 3 V2/CR-6 Enclosure Kit Kurulum Kılavuzu - Sayfa 10

3D Yazıcılar 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit 15 sayfaları.
Ayrıca 3DUpFitters Ender 3 V2/CR-6 Enclosure Kit için: Kurulum Kılavuzu (16 sayfalar)

Sayfayı Yazdır

4. Top Panel

Use access through the doors to attach the top of

the enclosure using M4 12mm screws.

5. Right Panel

The right panel contains the removable grommet cable

portal. Locate the grommet and insert it into the

grommet holder. This is where you'll insert the power

cable, USB cable, and any other wires you want to run

in or out of the enclosure.

Insert the grommet holder/grommet combination into the U-

shaped hole in the right side panel. This will enable you to

slide the enclosure oﬀ and onto the printer without unplugging

the cables.

You now have the option of keeping the printer's

control panel right where it is, attached to the

printer, or moving it to outside of the enclosure so

you can make adjustments without having to open

the door. There is an extender cable and an

external mount included with your kit, noting that

there is a diﬀerent kit for the CR-6 and Ender 3 V2

as the displays are diﬀerent.