ClearCube C7424 Hızlı Başlangıç Kılavuzu
Sunucu ClearCube C7424 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. ClearCube C7424 2 sayfaları. Zero client
Sayfayı YazdırFront
PCoIP Session
Indicator
Client Power &
Indicator
Remote PC
Power
USB Port
Smart Card
Reader
Reader Activity
Indicator
Rear
Serial Number
MAC Address
USB Ports
DVI #1
DVI #2
HD Audio Out
Power Jack
Kensington Security Slot
ClearCube Technology
Quick Start Guide
C7424 Zero Client
HD Audio Out
HD Audio In
Connection
Status
SC Fiber
8834 Capital of Texas Hwy N
Austin, Texas 78759
Zero Client Overview
ClearCube
®
C7424 Zero Clients connect to supported ClearCube
PC blades and virtual machines containing V5x20 Dual Host cards
to provide the following:
• 10/100 Mbps SC fiber
• Integrated smart card reader
• Support for up to two independently-configurable monitors
• PC–over–IP™ (PCoIP™) processors, delivering PC video and
audio over an IP network
• Three USB ports
• HD audio in (front) and HD 4.0 audio out
ClearCube PC blades are typically located in remote data centers.
Each blade user has a C7424 Zero Client on their desk, which they
use to connect to a remote blade over an IP network (consisting of
fiber and Ethernet segments). Users connect monitors, pointing
devices, and other peripherals to their client, enabling them to work
on the blade as if it was a local PC. The connection between the zero
client and the blade is over PCoIP protocol. Inside the blade, a
V5x20 Dual Host card manages the PCoIP session on the blade.
Monitors
Multimode
Fiber
C7424
Zero Client
Keyboard
Mouse
Client connected to blade with V5x20 card over fiber & Ethernet
NOTE: You can enable a zero client to receive an IP address from
a DHCP server. If the server does not assign an address
within a designated timeout period, the zero client uses a
default, fallback IP address. If you use these default
addresses and have DHCP enabled, you must wait 120
seconds before you can connect to a host. If you use the
direct connect methodology in your environment,
ClearCube recommends disabling the client's DHCP
setting to eliminate the need to wait 120 seconds before
connecting. See PCoIP System User's GUide at
www.clearcube.com/support
Ensuring Client & Host Firmware Compatibility
ClearCube PCoIP zero clients and host cards must use identical
firmware versions. If you are upgrading portions of existing
ClearCube deployments, ensure that all PCoIP devices use the
same firmware version. Additionally, devices must use firmware
version 3.0 or higher in a VMware
—Continued on Reverse—
voice 512 652 3500 www.clearcube.com
F6150 Fiber Transceiver
Ethernet
Network
Switch
Chassis and Blades
for more information.
®
View environment. See