esera automation 11233 Kullanıcı Kılavuzu - Sayfa 2

Anahtar esera automation 11233 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. esera automation 11233 7 sayfaları. Binary output / dual switch module for 1-wire bus

Sayfayı Yazdır
3
Technical data
Switching channels:
Switching voltage:
Switching power/power: maximum 10A continuous current, maximum 2200VA continuous current at Ohm
Fuses:
Data interface:
1-Wire component:
Supply voltage:
Power consumption12V: Idle mode, no output relay active: approx. 6mA
Button interface:
Connection:
4

Ambient conditions

Temperature, operation: 0 °C up to +50 °C
Air humidity:
Measurements:
Protection class:
Protection type:
Insulation strength:
5

Connection plan

Connection plan is available in our webshop
as own document
Note: a 10A preliminary fuse is required
in front of the screw terminals 8 and 11
Connection module top side:
7 = Relay 1, make contact
8 = Relay 1, input
9 = Relay 1, NC
10 = Relay 2, NC
11 = Relay 2, input
12 = Relay 2, make contact
1-Wire Bus
Module bottom side:
1 = GND (ground)
2 = 1-Wire data line
3 = +12V power
4 = GND (ground)
5 = Button interface 1, no external power allowed
6 = Button interface 2, no external power allowed
All rights reserved. Reproduction as well as electronic duplication of this user manual, complete or in part, requires the written consent of
ESERA-Automation or E-Service GmbH. Errors and technical modification subject to change.
www.esera.de
2, changeover relay (NO and NC contact)
maximum 250V direct power voltage or alternative power voltage
resistive load. minimum load 10mA
In case of capacitive or inductive loads, appropriate additional wirings, e.g. spark
suppressor capacitors must be considered. Maximum power and output will be reduced.
External preliminary fuse with 10A recommended
1-Wire Bus (12V, data and ground)
DS2413 (Dual I/O)
12VDC (+/-10 %)
both output relays are active: approx. 75mA in normal mode, approx. 40mA in power
saving mode
2, input for button (make contact), no external power allowed
Screw terminals (up to 2,5qmm wire cross section)
10 – 92 % (non-condensing)
35 x 90 x 70mm (BxHxD)
II
IP20
500VAC output to 1-Wire Bus, 250VAC output to output
11233 V1.0 R1.1 Manual
ESERA-Automation, E-Service GmbH 2019
Page 2 of 7