R2200
Dual-Processor Blade
3
CMOS Jumper
JP7
Normal operation
(default)
1
CMOS Jumper
3
Reset CMOS
on restart
1
ClearCube Technology
Quick Start Guide
The R2200 dual-Xeon blade offers dual integrated gigabit Ethernet con-
R2200_QSG_rev_b.fm — Enter your TB topic here
trollers and NVIDIA-based graphics to deliver a high-performance, high-
throughput solution to your enterprise computing needs.
INSTALLATION
The R2200 can be installed in any R4300 chassis, and in an R4200
chassis that is model C3130 or newer, depending on the interposer
installed on the R2200. Before installing your R2200 equipped with a
44-pin interposer in a R4200 chassis, make sure they're compatible by
opening the chassis front bezel and checking the label on the right-hand
side of the inside of the chassis bezel for the notation C3130 Cage. If
the model number is C3130 or later, a blade with a 44-pin interposer will
fit. If not, a 30-pin interposer must be installed on the blade before the it
will fully insert into the chassis.
Since the R2200 is a double-width blade, it needs to be installed in the
correct chassis slot pairs. Install the R2200 only in slots 1&2, 3&4, 5&6,
or 7&8.
To connect C/Ports to an R2200, use only the even-numbered C/Port
connectors 2, 4, 6, or 8, relative to those slot pairs. The odd-numbered
C/Port connections on the chassis are not connected to the R2200.
The first time you insert your R2200 into a powered-up chassis, the
green Power LED will light, and the R2200 enters a stand-by power
mode. You must depress the Power switch on the front panel of the
R2200 to bring it into a fully powered-on mode. After you do this, the
power modes function normally, and you can control the R2200's power
remotely.
To remove an R2200, press the Power switch, and wait for the power
light to go off. Then pull the blade from chassis, taking care to support
the end of the blade as you remove it completely from the chassis.
CAUTION: Some surfaces on the blade may be hot.
R2200 FEATURES
MSL Jumper
JP6
3
USB Mass Storage
devices function
1
normally (default)
MSL Jumper
3
USB Mass Storage
devices do not
1
function
8834 Capital of Texas Hwy N
Jumpers on the R2200
The R2200 provides jumpers that
enable Mass Storage Lockout (MSL)
and reset CMOS settings to defaults.
The default jumper settings are:
•
•
Austin, Texas 78759
voice 512 652 3500 www.clearcube.com
JP6, pins 2 and 3 jumpered, MSL
is disabled.
JP7, pins 1 and 2 jumpered,
CMOS settings retained on restart.
Sayfayı Yazdır