Divot DVTK Hızlı Kullanım Kılavuzu - Sayfa 2

Kablo Test Cihazı Divot DVTK için çevrimiçi göz atın veya pdf Hızlı Kullanım Kılavuzu indirin. Divot DVTK 4 sayfaları. Bare fiber testing device

Sayfayı Yazdır
Getting Started
n
Loading an OCC Cartridge
Before you begin:
An OCC cartridge needs to be loaded into the Divot® Module before
use. Six sealed cartridges are included in the case.
End Cap
1
2
Tabs
l
l
3
4
5
6
Instructions
n
Connect patch cable to OTDR or test equipment.
n
Break out a few inches of the fiber to be tested down to 250µm buffer.
Strip fiber down to 125µm cladding. Cleave fiber leaving a minimum of 3/4"
of fiber. Clean or wipe off fiber if needed.
n
Insert your prepared bare fiber end into the round opening on the end of
the OCC cartridge protruding from the Divot® module.
The bare fiber will be stopped by the attached patch cable assembly. If a connection is not
made on the first insertion, pull the fiber back slightly into the module and push forward again.
If using uncleaved fiber and are unable to get a successful connection after a few attempts,
remove the fiber and rebreak or cut the fiber again.
n
Proceed with testing.
OTDR
Caution: Always wear protective eyewear when working with bare or active fiber. Never look
into the end of the Divot® Module when patch cable is connected to active test equipment.
?
Questions? Please contact Customer Service at 1-866-640-3468 or visit www.fiberplus.com.
2
Load Cartridge
You do not need to remove the Divot® module from the patch cable
when loading a cartridge.
Unscrew and remove the End Cap to expose the split sleeve.
l
Remove the two plastic tabs (located on each end) from one of the
OCC cartridges included. Leave remaining cartridge sealed until
ready for use.
After removing the tabs from the OCC cartridge, push the larger end
into the sleeve.
Screw on the End Cap until it stops. The Divot® Module is now
loaded and ready for use. Place the dust cap included in the case
(not shown) onto the end of the cartridge protruding from the Divot®
module when storing the unit.
Insert Divot® module into the Desktop Mount/Holder by removing the
top half of the holder. Place the Divot® module into the cut out
section on the bottom half of the holder. Place the top section over
the Divot® module. The top section is held in place by magnets.
There should be a slight gap between the top and bottom section of
the Desktop Mount/Holder.
Divot® Module
Fiber