ESI 2TD-C48-24-BLK Montaj Talimatları Kılavuzu - Sayfa 2
İç Mekan Mobilyaları ESI 2TD-C48-24-BLK için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. ESI 2TD-C48-24-BLK 12 sayfaları.
Sayfayı Yazdır
Trada 2-leg
Caution
• Do not use impact drivers or other high-torque equipment. Use power drill
• Always check that screws used to attach components to the worksurface
Please review these instructions before beginning the installation. Use the illustrations below to check that all components needed for your installation
were provided with your order. Do not discard the packaging until the product works to your satisfaction.
Components and tools
A. crossbars (2)
B. legs with motor and cable (2)
C. feet (2)
D. universal side brackets (2)
F. power supply (1)
G. power cord (1)
H. handset (1)
I. control unit (1)
J. round rubber bumpers (10)
K. square rubber bumpers (2)
L. 3mm Allen key
used for set screws
M. 5mm Allen key
used for M8x16 socket screws
N. M8x16 flat head socket screws (8)
attach crossbars to motors
O. M8x16 round head socket screws (4)
attach feet to legs
P.
/
-20x
/
" Phillips flat head screws (4)
1
5
4
8
attach side brackets to crossbars
Q. #10x1" self-tapping Phillips pan head screws (4)
attach side brackets to worksurface
R. #10x2½" self-tapping Phillips pan head screws (10)
attach crossbars to worksurface
S. #6x
/
" Phillips self-tapping round head screws (10)
5
8
attach handset, control unit, and cord clips to
worksurface
T. cord clips (6)
Additional tools required
• Power drill with Phillips #2 bit for self-tapping wood screws only
• #3 Phillips screwdriver
on self-tapping wood screws only.
are not too long for the thickness of the table. The provided screws require
a minimum table thickness of 1.0".
K
J
L
M
A
A
D
B
N
Q
C
Page 2
Components and tools
thickness
E
E
F
G
I
T
O
P
R
S
table
D
H
B
C