ClearMirror 16101-2020120H Kurulum Talimatları Kılavuzu - Sayfa 2
Isıtıcı ClearMirror 16101-2020120H için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. ClearMirror 16101-2020120H 6 sayfaları. Fog-free heaters for vanity mirrors
Sayfayı YazdırNOTICE: All wiring must be performed by a licensed electrician. Follow the National Electrical
Code or local codes as applicable.
WARNING: Failure to follow instructions could result in death or serious injury.
NOTICE: ClearMirror height is usually 2 inches higher than the tallest user's height.
NOTICE: ClearMirror heater must be smaller than the mirror. Leave at least a 1" space from
mirror edges to the heater edges.
General Guidelines
Install the Original ClearMirror to a junction box in accordance with all applicable safety,
national and local electrical codes. All wiring between the mirror heater and the bathroom light
junction boxes must be installed per local and national electrical codes using wire system
identified by the National Electrical Code. Consult a qualified electrician for all wiring.
• Do not install on mirrors located on uninsulated external walls.
• Only wire the pad to a 110/220 volt power supply.
• These installation procedures are for mirrors that are not permanently installed. Consult
local authorities for variations in installation.
• Do not install is product is damaged. Do not bend, alter, submerge in water, or use product
for purposes other than described. Do not overlap ClearMirror pads if using more than one
on a mirror.
• Mirror must be larger than ClearMirror heater.
• Use caution with all electrical appliances. Install according to these instructions.
Installation
Install the Original ClearMirror to a junction box in accordance with all applicable safety,
national and local electrical codes. All wiring between the mirror heater and the bathroom light
junction boxes must be installed per local and national electrical codes using wire system
identified by the National Electrical Code. Consult a qualified electrician for all wiring.
• Choose the mirror defogger location.
• Install an electrical junction box.
• Adhere the mirror defogger to the back of mirror.
• Wire mirror defogger to junction box to switched 110/220 power supply – preferably
bathroom light switch or fan to ensure it is turned off when not in use.
• Use two people for safety.
TOOLS NEEDED
Electrical tape, flashlight, 4-yellow or red wire connectors, non-sheathed wire cable,
remodeler's junction box, utility knife, wire strippers, screwdriver, pliers and keyhole saw.