ESi Ergo VICTORY 2VT-C36-30 Series Talimatlar Kılavuzu - Sayfa 3

İç Mekan Mobilyaları ESi Ergo VICTORY 2VT-C36-30 Series için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. ESi Ergo VICTORY 2VT-C36-30 Series 8 sayfaları. 2 leg electric table base

Sayfayı Yazdır

ASSEMBLY

STEP 1

With the table top facing down on a soft, clean

surface, arrange the cross channels and top

supports as shown.

• Positioning does not need to be exact at this time.

• Mounting tabs on the cross channels face inward,

toward each other.

• Holes on the top supports are offset to the rear.

STEP 2

Use an 5mm Allen key to loosen the M10 set screws

on the cross channels (two on each side of center).

STEP 3

Adjust the cross channels to their approximate final

lengths, as shown.

• Center the inner piece in each cross channel.

STEP 4

Attach the side legs to the cross channels and top

supports with six M8x12 screws per leg.

• Use a 5mm Allen key.

• Two screws attach to each cross channel and

two screws attach to the top supports.

STEP 5

Attach a foot plate and foot to each of the side

legs with the M6x35 screws.

• First, place the foot plate onto the leg with the

smooth side up.

• Position the foot over the foot plate, as shown.

The short side of each foot should face the rear.

• Screw the foot securely in position using a 5mm

Allen key.

VICTORY 2 LEG ELECTRIC TABLE BASE

Cross Channel

Mounting Tab

Loosen

Set Screws

Center

Inner Piece

Rear

Foot Plate

Top

Support

M8x12

M6x35

Front

Side

Legs