Alto-Shaam Halo HeatI TM2-48/DLX Kurulum Operasyon ve Bakım - Sayfa 4
Merchandiser Alto-Shaam Halo HeatI TM2-48/DLX için çevrimiçi göz atın veya pdf Kurulum Operasyon ve Bakım indirin. Alto-Shaam Halo HeatI TM2-48/DLX 19 sayfaları. Island takeout merchandiser
Sayfayı Yazdır
I N S T A L L A T I O N
S I T E I N S T A L L A T I O N
D
N G E R
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
C
U T I O N
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN IN
OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
S I T E I N S T A L L A T I O N
In order to maintain
established National
Sanitation Foundation
standards, all
stationary floor
models must be sealed
to the floor with a
R.T.V. or silastic
meeting N.S.F.
requirements or
have 6" (153mm)
unobstructed clearance
beneath the unit.
1. The appliance must
be installed on a stable and level surface.
2. DO NOT install this appliance in any area where it
may be affected by any adverse conditions such as
steam, grease, dripping water, high temperatures,
or any other severely adverse conditions.
3. DO NOT install a heated display case near a cold
air source such as a freezer, air conditioning vents,
or in any area where outside air fluctuation can
affect performance.
4. This appliance must be kept free and clear of
any obstructions blocking access for
maintenance or service.
®
#880 • INSTALLATION/OPERATION/SERVICE MANUAL • 3.
C
U T I O N
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
C
U T I O N
The performance of this unit has been
optimized using the factory provided
bulbs. These bulbs should be
replaced with an exact replacement or
with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb filament.
A number of adjustments are associated with
initial installation and start-up. It is important
that these adjustments be conducted by a
qualified service technician. Installation and
start-up adjustments are the responsibility of the
dealer or user. These adjustments include but are
not limited to thermostat calibration, door
adjustment, leveling, electrical hook-up and
installation of optional casters or legs.
LEVELING
Level the appliance from side-to-side and
front-to-back with the use of a spirit level.
We recommend checking the level periodically to
make certain the floor has not shifted nor the
appliance moved.
NOTE: Failure to properly level this appliance
can cause improper function.