Akiyama MC-Club Kullanım Kılavuzu - Sayfa 6

Müzik Mikseri Akiyama MC-Club için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Akiyama MC-Club 12 sayfaları. 19 inch 5 channel

Sayfayı Yazdır

FUNCTIONS

Rear Panel

INPUTS

1.- Phono inputs L,R - Insert here connectors from turntables

(MM) type. These connections are of dual use, you can turn them

from Phono to Line and viceversa by means of the knob (2).

2.- Phono/Line switches - Allows us to change the input level

from Phono to Line.

Important: take good care to match switch setting and type of

signal connected.

3.- Phono Grounding posts - Connects to the turntable ground

connector to eliminate electrical hum. Ground wire and

connectors are usually supplied with turntables.

4.- Line level inputs L,R - Insert here connectors from any line

level signal device. That is CD Player, MD player, Cassette

Player etc.

5.- Mic input (Jack 6.3) - Connect there the Microphone ( Jack

6.3 TRS or TR). All Microphones are alloted with a symetric

connection. That means that unwanted noises absorved by the

Mic cable will be erased provided we use TRS Jack.

6.- Mic Inserts -All three Microfones are equiped with an Insert

Loop to hook an external signal process device. See more of that

at:

OPERATING THE MIXER; MICROPHONE INSERTS

OUTPUTS

7.- Master output L,R (RCA) - Connect to the amplfier system.

Normally RCA output are used at domestic setups or when cable

lines are short.

8.- Balanced Master output - Balanced Jack 6.3 stereo

Connectors

RCA

Line and Phono inputs and outputs

Jack 6.3 mono

Microphones.

connection that would need a TRS Jack we can

use a TR Jack. However we have to be careful

with the Mic cable not absorving unwanted noises

that on a symetric connection with a TRS Jack

would not appear.

Jack 6.3 stereo

- Headphones

- Microphones

- Mic Inserts

- Master Bal

mc club

connectors are typically used to connect to the amplfier system

for professional use. Specially when cable lines are long and

therefore can caught unwanted noise.

9.- Booth output L,R - This is a second Master output normally

used for monitoring at the DJ cabin (when available).

10.- REC L,R - The record output is not affected by the Master

volume control. It can be used to record even while the master

volume is off.

MAINS CONNECTION AND ON/OFF SWITCH

11.- AC Input - Input connection for the inboard power supply.

Connect it to the wall outlet socket.

Always assure that the tension and frequency of the outlet

matched the specified at the mixer.

12.- Power switch: With the AC plug plugged into the wall outlet,

the unit may be switched on by means of this switch; a second

press of the switch will switch the unit off again. The

corresponding LED will illuminate red when the unit is switched

on; please note that the LED will not immediately turn off after

switching off due to the PSU capacitors must discharge

first.Attention: Always take care of switching on your mixer first

and your amplifier at last to avoid switching noise damaging your

speakers; for switching off, switch off your amplifier first and

your mixer at last.

Although we have a symmetric