ClearOne MAX IP Kullanıcı Kılavuzu - Sayfa 6
Konferans Telefonu ClearOne MAX IP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ClearOne MAX IP 6 sayfaları. Conferencing phone
Ayrıca ClearOne MAX IP için: Şartname Sayfası (3 sayfalar), Kullanıcı Kılavuzu (6 sayfalar), Veri Sayfası (2 sayfalar), Birlikte Çalışabilirlik Kılavuzu (4 sayfalar), Broşür (2 sayfalar), Kullanıcı Kılavuzu (7 sayfalar)
Sayfayı Yazdır
USING THE PHONE IN A THREE-WAY CALL
1. Press the
>
Press the
2. Press the
3. If either of the other parties hangs up during the three-way call, then you will hear a beep to indicate that
the party is gone. The remaining party stays connected to the call.
TO MAKE AN OUTBOUND CALL WHILE ON ANOTHER CALL
1. Press the
a second line dial tone.
2. Dial the second party's phone number.
>
If you receive a busy signal or are routed to voicemail, then press the
return to the first party.
3. Press the
>
TO ACCEPT AN INBOUND CALL WHILE ON ANOTHER CALL
1. The phone rings (unless the ringer is muted) and the LEDs flash green.
2. Press the
the incoming call.
>
3. Press the
>
TONES AND ALERTS
4
Technical Services: 800.283.5936
key to place both lines on hold.
HOLD
Note: The LEDs flash red when a call is on hold.
key a second time to take both lines off hold.
HOLD
key to hang up both lines.
ON/OFF
key and then press the
HOLD
Note: Stored numbers are not available for dialing a second party.
key to toggle between the first and second parties.
HOLD
Note: You cannot join the first and second parties together in a three-way call after calling the
second party in this fashion; a three-way call must be initiated by pressing the
as explained above (see
TO MAKE A A N OUTBOUND THREE-W W AY CALL
key and then press the
HOLD
Note: If you want to disconnect the incoming call after answering it, press the
the second call and then press the
key to toggle between the first and second parties.
HOLD
Note: You cannot join the first and second parties together in a three-way call after answering an
incoming call; a three-way call can only be initiated as an outbound call (see
for more information).
THREE-W W AY CALL
Tone/Alert
Description
Con rmation
A tone will play upon successful programming entry.
Reject
A tone will play if you attempt to do any of the following:
• enter an invalid programming entry
• use a speed dial key that has not been programmed
• enter a 45th digit when predialing
• enter a 17th digit for user phone number
• enter a 31st digit for speed dial key (One-Touch
key. The first party is put on hold and you are connected to
ON/OFF
key. The first party is put on hold and you are connected to
ON/OFF
key to take the first party off of hold.
HOLD
(One-Touch Conferencing or service center)
Conferencing or service center)
key to terminate the call and
ON/OFF
CONFERENCE
for more information).
key to hang up
ON/OFF
TO MAKE A A N OUTBOUND
MAX IP tones and alerts
FIGURE 6
key first,