ClearOne WS800 Hızlı Başlangıç Kılavuzu - Sayfa 5

Mikrofon sistemi ClearOne WS800 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. ClearOne WS800 10 sayfaları. Wireless microphone system antenna application guide
Ayrıca ClearOne WS800 için: Hızlı Başlangıç Kılavuzu (15 sayfalar), Manuel (5 sayfalar), Hızlı Başlangıç Kılavuzu (13 sayfalar), Başvuru Kılavuzu (12 sayfalar), Başvuru Kılavuzu (11 sayfalar)

Sayfayı Yazdır

1. How to Sync Transmitters with the Receiver

Receiver:

FRONT PANNEL:

ClearOne receiver main-frames hold either four or eight, independent, 24-bit digital audio receiver modules.

There is a front-panel mixed audio output for headphones or direct recording. Each module shares the main-

frame's two antennas for full-diversity. Up to eight receiver main-frames can be daisy-chained together into an

antenna network that shares two antennas. This eliminates the need for external antenna distribution amps.

Main-frames can be connected to form an Ethernet network that monitor and control the system via a computer.

Main-frames also have USB and RS232 connections for serial monitor and control.

Made In USA

1. Antenna Front Mounting Hole: Use back-to-front TNC cables included.

2. Receiver Module. See details below

3. Mixed audio volume control.

4. USB Port. Connect to computer for ClearOne Remote control. Run software to monitor/edit system

parameters, scan for RF interference and download firmware upgrades.

5. Mixed audio output, 1/4" (See headphone mode - Pg. 3) phone jack for monitoring individual channels

or mixed channels.

6. Power Switch.

Receiver Module:

MODULE:

Modules are designed for quick and easy

field replacement for added redundancy.

BATTERY

SLOT 3

CH 1

FUNCTION

SELECT

AUDIO

AES256

(SYNC)

STATUS

Select Next Function: Move the cursor to the next menu function on the display

(Under construction)

IR Sync LED: Sends IR information to SYNC the receiver and transmitter (SYNC pg4)

Select Previous Function: Move the cursor to the previous menu function (Under

construction)

Soft Key Left: Select the choice displayed in the bottom left of the display 4 & 6

pressed at the same time: Sends SYNC signal from receiver to transmitter (SYNC pg4)

Status LED:

•

Green --> The channel is ON and un-muted

•

Red --> The channel is OFF

•

Flashing Red --> Encryption key mismatch, Re-sync receiver with transmitter

•

Amber --> The receiver is muted or GPIO is triggered

Soft Key Right: Select the choice displayed in the bottom right of the display

RF BARS

ANTENNA DIVERISITY

AUDIO LEVEL

BATTERY LEVEL

CHANNEL NAME

ENCRYPTION

(Colored text indicates status)

STATUS:

ON = Green

OFF = Red

MUTE = Amber

KEY = Flashing Red ("KEY" = mismatched encryption key)

FREQUENCY

USB

PHONES

POWER