ClearPlus WH5B Manuel - Sayfa 4

Su Filtrasyon Sistemleri ClearPlus WH5B için çevrimiçi göz atın veya pdf Manuel indirin. ClearPlus WH5B 5 sayfaları.

STEP 5. Remove the protective plastic wrap from one of the filter cartridges and place it in the

appropriate blue housing sump. At the bottom of the sump, there is a raised portion in the middle

(standpipe) that will help center the filter in the housing. The standpipe will fit inside the hole

that runs through the middle of the filter cartridge. Check to make sure that the O-ring is seated

properly in the grove at the top of the blue housing sump, then screw the blue housing sump

containing the filter cartridge onto the black housing cap. Use the spanner wrench to tighten.

Repeat this step for the other filter. Store any spare filters in a cool dry place for future use.

STEP 6. Turn on the water and inspect all plumbing connections very carefully for leaks. Also

inspect the seal between the black housing caps and the blue housing sumps to ensure that the

O-ring has formed a good seal. Tighten this connections again using the spanner wrench if

necessary. If this connection still leaks, turn off the water supply and check to make sure that the

filter is aligned properly in the housing and repeat your test for leaks. When you are confident

that all connections are sound, run cold water for 5 minutes at any faucet to purge air out of your

system and flush the filter before use. New cartridges may release "fines" (very fine black

powder) after installation. Wait one hour, and flush again for another 5 minutes prior to using the

water.

Important Notes:

1. The manufacturer recommends that the blue housing sumps be replaced every 10 years or if

you notice any cracks or damage.

2. This filter system should not be used with water that is microbiologically unsafe or of unknown

quality without adequate disinfection before and/or after the system.

3. Water filter systems should never be exposed to freezing temperatures - severe damage to the

filter and housings could result. Such damage is not covered under any warranty.

4. After prolonged periods of non-use (such as a vacation), it is recommended that the system be

flushed thoroughly for at least 5-10 minutes before using the water.

5. The contaminants or other substances removed or reduced by this water treatment device are

not necessarily in your water.

6. If you suspect that your water pressure will at any time exceed the maximum rating of 90 PSI

(6.2 bar), a pressure regulator must be installed before the system. It is recommended that the

pressure regulator be set at 75 PSI (5.2 bar) or less.

Maintenance and Filter Replacement Information:

To maintain the optimal performance of your whole house water filter system, filters should

always be replaced in accordance with manufacturer specifications. Filters may need to be

replaced more frequently then specified, depending on the level of contaminants, particularly

sediments, in your water supply. If significant water pressure reduction is noticed, the filter may

have become clogged. We recommend that you keep a "Filter Replacement Log" attached to your

system where you can record the date of filter changes, and that you write a note on your

household calendar reminding you of filter replacement schedules.

Replacement Filters: Pentek RFFE20-BB & Pentek DGD-5005-20

Replacement Filters can be Obtained as Follows:

Phone Toll Free 1-866-376-2690 or

Order Online at: www.home-water-purifiers-and-filters.com