ClearRF WRE2710-S Operatör El Kitabı - Sayfa 8

Genişletici ClearRF WRE2710-S için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. ClearRF WRE2710-S 12 sayfaları. Wireless network range extender
Ayrıca ClearRF WRE2710-S için: Kullanım Kılavuzu ve Kurulum Kılavuzu (12 sayfalar)

Sayfayı Yazdır

Connect the Outdoor Signal Antenna connector to the ClearRF amplifier SMA connector marked

"Antenna".

Plug the 12V Hardwire DC Cable (#3 on Parts List) into the vehicle fuse block. You must connect

the red wire to a positive terminal from the fuse panel with a 3 ampere fuse rating. The black

wire should be attached to a ground of the vehicle. Power may also be provided to the amplifier

using a 12V cigarette lighter adaptor. (not included, available at www.clearrf.com)

Insert the Hard Wire DC Cable connector plug into the amplifier and watch the LED indicators.

LED Diagnostics

Once the amplifier is installed properly and power is applied, the LEDs will both turn on followed by

the green LED flashing. The green LED will flash while the amplifier increases its gain to the optimum

level. The red LED may also flash during this stage while the gain (power) is properly set on the

amplifier. When power control is established, the green LED will remain constantly on. You may see

the green and red LEDs flash back and forth, THIS IS NORMAL. In areas where the cellular network is

adequate, the amplifier will maintain a maximum power level acceptable for normal operati on and

prevent overloading the wireless phone, as well as keeping RF signal levels at a minimum for a

healthy environment. If the red LED is constantly on and the green LED is off, the amplifier has

detected a fault. The amplifier will shut down automatically and restart. If the fault persists,

reposition the antenna until normal operation is achieved. - Once normal operation is established,

you may permanently mount the antennas in the locations you chose in the prior steps.

MAN-5446-001 Rev 7