ClearSpan 104903 Montaj Talimatları Kılavuzu - Sayfa 6

Sera Kiti ClearSpan 104903 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. ClearSpan 104903 19 sayfaları. Premium solar star greenhouse

Sayfayı Yazdır

2. Secure the frame tubes at each corner using a

corner bracket and 3/4" Tek screws.

NOTE: To maintain the proper dimensions, seat the

frame tubes for the door and non-door ends into the

each corner bracket. See above and below illustrations.

Door (or Non-Door)

Frame Tube

Side Frame Tube

Top View of Frame Tubes and Corner Bracket

NOTE: If the metal frame was not assembled on the

recycled plastic lumber frame, set the metal frame in

place on the plastic frame base and continue.

3. After assembling the metal base and securing it with

the corner brackets, choose the first two panels (as

shown in the following diagram) and set these on the

metal frame.

NOTE: Install the panels with the UV-protected

polycarbonate to the outside and the frame to the inside.

Visit www.ClearSpan.com for additional products and customer assistance.

Door End

Base Frame

Side

Panel

NOTE: The angled end panel is installed first and is

seated into the corner bracket. The short, side panel is

installed next and is flush with the front of the angled

panel.

Door (or Non–

Door) End

Angled Panel

View is from the inside of the greenhouse looking at the

corner where the panels meet.

4. With the panels set in the corner and the edges tight

together, secure the panels to the corner bracket

using 3/4" Tek screws.

5. Secure the corner with a 3" x 3" square plate.

NOTE: All 3" x 3" square plates are attached to the

greenhouse on the inside using self-tapping 3/4" Tek

screws. See the photo that follows.

Non-Door End Panel

Side Panel

Frame Base

5 of 18