ClearSpan 105366 Manuel - Sayfa 7

Sera Kiti ClearSpan 105366 için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan 105366 13 sayfaları.

Sayfayı Yazdır

INSTALL DOOR JAMBS AND HEADER

Gather the parts:

•

Door jambs (#EG12W1200)

•

Door header (#EG00W1201)

•

Square head screws (#FAS8)

•

1.05" Fabric clips (#105107)

•

90° Connectors (#104637)

•

Phillips head screws (#FAF25P)

•

Tek screws (#FA4482)

Consult the diagrams to assemble and attach the two (2) door jambs and header.

1. Gather the two (2) door jambs and the two (2) 105107 fabric clips. Attach the fabric clips to the angled ends of the

jambs using a FAS8 square head screw. Center the clip on the end brace as shown below.

2. Set assembled door jambs into position by seating the plain end against the angled anchors and clipping the top of

the door jambs with the fabric clips onto the rafter. Verify the jambs are straight and evenly spaced.

3. Once in position, secure clips by installing a Tek screw through the clip and into the rafter from the inside of the

shelter. Drill a hole through the fabric clip if needed.

4. Secure lower ends of the door jambs by installing two square head construction screws through each angle anchor

and into the door jamb from the outside of the shelter. If needed, pre-drill the holes through the anchor stake for

each FAS8 screw.

5. Measure the door panels and allow for clearances. Using the measurements from the door panels, set door header

into position and install using 90° connectors and Phillips head screws.

Step 1

FAS8

105107

EG12W1200

Step 4

Outside of

shelter

Inside of

shelter

FAS8

Revision date: 04.01.10

Inside View

Step 3

Tek screw

Inside View

Step 5

104637

EG00W1201

CLEARSPAN

EG00W1201

EG12W1200

Angled Anchor

Ground Level

Drawings may show a different but similar model.

Step 5

Measure door panels

and install header.

Maintain an even gap

of approximately 1/4"

between the top and

bottom of the door

and between panels.

END FRAME KIT

™

Outside View

EG12W1200

Angled Anchor

Step 1 & 3

Views are seen

from the inside of

the shelter.

Step 4

Ground Level