Dixon Bayco FT310 Bakım ve Kullanım Talimatları - Sayfa 3

Aksesuarlar Dixon Bayco FT310 için çevrimiçi göz atın veya pdf Bakım ve Kullanım Talimatları indirin. Dixon Bayco FT310 6 sayfaları. Trailer mounted individual sockets

Sayfayı Yazdır

FT300 Series Trailer Mounted Individual Sockets

Wiring Instructions

When wiring the sockets to an onboard monitor it is highly recommended

using FloTech FT401 jacketed 5-conductor cable when wiring a new

system. FloTech cable is designed to be oil, UV, and abrasion resistant.

We incorporate a noble tin plated stranded copper wire which resists

corrosion. These features will provide years of reliable service.

1. After all sensors are mounted in each compartment, align the conduit

openings so they face the roll over rail.

2. Thread in cable glands and pull a length of cable through the conduit

openings between each sensor.

3. Cut to length leaving approximately 8" extra length exiting the top of

each probe holder.

4. All socket cables must enter or leave through one of the ½" NPT

openings. Use FloTech FT402 ½" NPT cable glands to ensure a water

tight seal. Unused conduit openings must have a ½ NPT pipe plug

installed. Use pipe dope on all ½" NPT threads to ensure a water tight

seal.

5. Wire the sockets according to diagram 2 below. Double check your

wiring connection when complete. It is highly recommended to use a

small amount of Silicone RTV sealant in each crimp connection. Fill the

FloTech butt end crimps with Silicone RTV sealant prior to inserting the

wires then crimp. This will provide a watertight and vibration resistant

connection.

When wiring is complete, replace each sensor cap and O-ring.

Do not pinch a sensor wire when installing the cap.

FT300 Series

REV JANUARY 2011