ClearSpan Premium Solar Star 104918 Montaj Talimatları Kılavuzu - Sayfa 14
Sera Kiti ClearSpan Premium Solar Star 104918 için çevrimiçi göz atın veya pdf Montaj Talimatları Kılavuzu indirin. ClearSpan Premium Solar Star 104918 17 sayfaları. Home-attached greenhouse
Sayfayı YazdırFOIL TAPE AND SILICONE SEALANT
Foil tape and silicone sealant are included with the
greenhouse to seal the spaces between the panels if
desired.
Tape and sealant can be applied from the outside or the
inside depending on the desired results.
For some panels, tape can be applied at the seam
between panels and under the polycarbonate by
removing the screws and washers, installing the tape
under the polycarbonate panels, and reinstalling the
screws.
Tape or sealant can also be applied to the seam that will
be under the flashing when that is installed.
Foil Tape
View above shows foil tape applied over the seam of two
panels on the inside of the greenhouse.
WARNING: FLASHING IS SHARP! WEAR
GLOVES WHEN HANDLING AND INSTALLING
ALL FLASHING.
Visit www.ClearSpan.com for additional products and customer assistance.
ATTACH THE FLASHING
The metal flashing is used to finish the outside panel
edges. The flashing is shipped in 6' lengths and must be
cut to fit.
Use Tek screws (1 1/2") and neo-bonded washers to
install the flashing.
NOTE: Flashing is installed along the edges of the door
and non-door end panels as identified by dashed lines in
the diagram below.
ATTENTION: Before installing the flashing, remove the
screws holding the polycarbonate panels to the roof and
end panel frames. See the dashed lines above.
Remove and
Reinstall Tek Screws
White dashed line shows the edge of the flashing under
the polycarbonate of the roof panel.
Flashing
13 of 16