ClearSpan Pro Solar Star R035B00009A Manuel - Sayfa 8

Sera Kiti ClearSpan Pro Solar Star R035B00009A için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan Pro Solar Star R035B00009A 13 sayfaları. Greenhouse door kits

Sayfayı Yazdır

SINGLE TWIN-WALL DOOR ASSEMBLY (continued)

10.

Mark the plate mounting hole locations on the panel

and drill a 5/16" hole through the panel and door

frame. Support frame with a block of wood if needed.

11.

Slide back mounting plate into position, square it with

the mounting holes and front plate and secure using

two (2) ¼" x 3" bolts and lock nuts. Verify that latch

turns freely. Mount door latch guide (slotted plate)

using the remaining ¼" x 3" bolts. Position so latch

handle is level. See below.

Latching

Door Latch

Plate

Guide

12.

After assembling the door, evenly space the three (3)

hinges along the door frame of the door and attach

the hinges to the assembled door using Tek screws.

Twin-Wall Single Swinging Door

Horizontal

Position

With assistance, set the assembled door in the end

wall door frame and secure hinges to the door jamb

using one Tek screw per hinge at this time.

Locations of door hinges may vary.

NOTE: Verify that there is sufficient clearance along

all door edges to allow the door to swing freely in

the opening. If end panels are installed, either attach

to the outside of the end panels as shown above or

loosen the panels, secure the hinges directly to the

door jamb, and reinstall panel fasteners.

13.

Test the door operation, adjust hinges as needed,

and install the remaining Tek screws.

14.

Mount latching plate to door jamb frame using Tek

screws. The screws supplied with the latch are not

used for metal jambs. Trim end panels as needed.

15.

After installing the door to the frame, read the care

and maintenance section.

Revision date: 05.28.10