ClearSpan R024B00005 Kurulum Kılavuzu - Sayfa 5

Sera Kiti ClearSpan R024B00005 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. ClearSpan R024B00005 7 sayfaları. End panel

Sayfayı Yazdır
FABRIC END PANEL INSTALLATION
The following procedure describes installing an end panel
that includes D-rings at the top. Complete these steps to
install an end panel of this design.
Required parts include:
•
End panel
•
103620 black 1" strap
•
QH1061 ratchets
•
1.315" x 75" pipe (#131S075)
•
FA4482B Tek screws
*Panels shown may differ from actual panel. Regardless
of frame width or whether the panel is plain or zippered,
this part of panel installation is the same for all panels.
1.
Position the panel flat on ground with the long edge
against the bottom end wall frame member. (The
D-rings should be visible when the panel is positioned
as shown below.)
2.
Locate the D-rings near the top edge of the panel
and tie a section of black strapping (or rope) to the
center-most D-ring. Tie two additional straps on each
side of the center D-ring, allowing a few feet to remain
between the straps.
Revision date: 06.21.12
Fabric End Panel Installation
DO NOT ATTEMPT
TO PULL THE END
PANEL INTO POSITION
ON WINDY OR STORMY
DAYS!
With the temporary straps (or customer-supplied rope)
in place, pull the end panel up to the end rafter and
secure the end panel to the end rafter using small
sections of the black strap. Keep the panel centered.
Outside of the End Panel
NOTE: Approximately 1 to 2 feet of the end panel
material will remain at and run along the base of the
end wall. In a later step, this can be wrapped under as
desired or can remain as a skirt to direct water away
from the shelter.
Temporary straps
in D-rings.
End Panel
View is from the inside looking up at the rafter. Rafter
design may differ from actual rafter. Photo shows
optional end wall frame.
These straps are used to temporarily hold the end
panel in place. After securing the end panel in the
following steps, remove the temporary straps.
5