ClearSpan R024B00008 Manuel - Sayfa 7

Sera Kiti ClearSpan R024B00008 için çevrimiçi göz atın veya pdf Manuel indirin. ClearSpan R024B00008 13 sayfaları. Twin-wall polycarbonate end panel kit 20' wide & 24' wide

Sayfayı Yazdır
END PANEL INSTALLATION (continued)
7.
Measure between the side H-channel sections of the center
panel (or panels) and cut H-channel to length. See diagrams
for panel size.
8.
Install H-channel along the top of the installed lower panel (or
panels). Upper panels slide into this H-channel (diagram B).
9.
Set the first upper panel in place into the H-channel of the
lower panel and align the edges with the lower panel. Do not
attach at this time. Have an assistant hold the panel against
the end frame. Do not install panels on windy or stormy days.
10.
Using the end rafter or end cap as a guide, trace along to
mark the panel height. Set the panel on a protected surface
and cut the panel to the correct size. Tape the cells at the
upper end using vent tape.
11.
Measure the distance along the vertical edges of the panel
sides and cut H-channel to the measured length. For
greenhouse frames equipped with the 108867 end cap, the
H-channel, when installed properly, is positioned under the
end cap.
12.
Set the panel back in place,
to the outside, against the end wall and install the H-channel
along the edges. (Greenhouse frames only: Position the top
end of the side H-channel under the lip of the end cap and
onto the polycarbonate panel.)
13.
Verify that the panel is square and in the desired position,
and attach the panel to the end frame using Tek screws and
washers.
Actual end frame and panels may
differ from frame shown. Consult the
panel diagrams located in the Quick
Start section for the end kit ordered.
24' Wide End Wall
Measure here for
Step 7.
Revision date: 08.22.13
End Panel Installation
with the UV-protected side facing
Trim
excess panel
C
4' x 8'
Brace
Panel
4' x 8'
Panel
GROUND LEVEL
B
H-Channel
End Cap
Trim
excess panel
4' x 8'
Panel
B
4' x 8'
Brace
Panel
Upper
Panel
Lower
Panel
Applies to
greenhouse
frames
equipped with
the 108867
end cap.
End Rafter
Panel
C
GREENHOUSE FRAMES
ONLY: Trim H-channel as
needed to fit under the
lip of the 108867 end cap
attached to the end rafter.
Install Tek screws and
washers through the
panel and into the end
wall braces. Evenly
space the screws at 12".
7